Wireless remote vibrator has two parts: vibration receiver and transmitter; small enough for you to carry in the pocket. Press the button on transmitter and the receiver will vibrate to alert. The receiver can be controlled by transmitter from any place within a reliable distance; wireless signal pass through walls, floors and doors. It is also suitable for person with hearing impairment. For example, when you are at the kitchen, you can use remote vibrator to alert him/her at living room to come. Operation video please visit http://www.youtube.com/watch?v=Q5KDC9yFJIY
You can control the receiver with transmitter (remote control) from any place within a reliable distance, the wireless signal can pass through walls, floors and doors.
Reliable control: The transmitter (Encoding) and the receiver (Decoding) use an 8-bit code.
One/several transmitters can control one/several receivers simultaneously.
If you use two or more receivers in the same place, you can set them with different codes.
Transmitting Frequency: 315MHz
Vibration Receiver:
Model No.: Z-02
Mode: Vibration
Decode: Learning code
Power Supply (Operating Voltage): AAA 1.5V Battery
Size: 58mm x 36mm x 15mm
Transmitter:
Model No.: CS-4
Channel: 4 CH
Remote Control Distance: 50m / 150ft (theoretically)
Encode: Fixed code by soldering
Unit size: 60mm x 25mm x 15mm
Power Supply: 1 x 27A -12V battery (included, can be used for 12 months)
Usage:
Delete all stored codes: Press and hold the button of the receiver for about 2 seconds until LED light is off, then release the button, all stored codes have been deleted successfully. At this time, the transmitter cannot control the receiver.
Learning remote controls: 1) Press the learning button of the receiver, LED light is on, the receiver is in the status of LEARNING. 2) Press any button of remote control within 7 seconds, if LED light flashes twice slowly then off, it means LEARNING is successful. If LED light is off after 7 seconds, it means LEARNING is failed and the receiver quits the status of LEARNING. 3) The receiver can learn several remote controls of different codes.
1) Press button A: The receiver vibrates once. 2) Press button B: The receiver vibrates twice. 3) Press button C: The receiver vibrates three times. 4) Press button D: The receiver vibrates four times.
Package Include:
1 x Vibration Receiver: Z-02 (4 Vibration Modes)
1 x Transmitter: CS-4
1 x User manual
Note:
The theoretical distance is 50m, which shall be operated in an open ground; no barriers and no any interference. But in actual operation, it is hindered by trees, walls or other obstacles, or interfered by other signals. Therefore, the actual distance can not reach 50m. If you need longer range, please choose other series of remote control, such as CB Serie (1000m/3000ft) - Click here; Or you can add the External Extend Antenna (model: 0020909) on the receiver for improve the range - Click here.
