315MHz 100M Wireless Vibrative Transmitter & Receiver Kit
Transmitter:Model No.: 0021000 (C-1)With Sliding Cover: Slide up when it doesn’t work (to protect the button). Slide down the button will appear.Shell Color: Wood Color / WhiteChannel/Button: 1Button Symbol: no symbolOperating Voltage: 12V (1 x 23A -12V battery, can be used for 12 months)Operating Current: 6mAOperating Frequency: 315MhzEncoding Chip: PT2262 / PT2264 / SC2262Encoding Type: Fixed code by soldering, up to 6561 codesTransmitting Distance: 100m / 300ft (theoretically)The distance of 100m is a theoretical data, it shall be operated in an open ground, no barriers, no any interference. But in the practice, it will be hindered by trees, walls or other constructions, and will be exposed to some interference by other signals. Therefore, the actual distance may or may not reach 100m.If you stretches the telescopic antenna, it can have a further working range, which is twice as much as it used to be.Modulation Mode: ASKOperating Temperature: -20 ° C to +70 ° CUnit Size: 58mm x 39mm x 16mmWeight: 30gUses: garage doors, motorcycles, car alarm products, home security products, wireless remote control products, industrial control products. How to set up the 8-bits code of the transmitter:1. Open the transmitter shell, then you will see the circuit board. There are two rows pads and one row of chip feet on the back side.2. The upper row of pads is “L” side, and the lower row of pads is “H” side.3. If solder the middle row of chip feet to the “L” side, it is code 1. If solder the middle row of chip feet to the “H” side, it is code 2. Don’t solder to any side, it is code 0.4. The 8-bits code order is from left to right (from D1 to D8).5. Here is an example, the 8-bits code in the picture is 01121101, solder as the following way:6. Code 0: don’t solder any side, like D1 and D7.7. Code 1: solder to the “L” side, like D2, D3, D5, D6, D8.
You can turn on/ off the receiver with transmitter (remote control) from any place within a reliable distance.
Wireless RF signal can pass through walls, floors, doors or windows.
Adopt single chip technology to build millions of code.
One/several transmitters can control one/several receivers simultaneously.
Two or more transmitter & receivers set can be used in the same place.
Transmitting Frequency: 315MHz
Model No.: Z-04
Decode: by learning
Power Supply: 1 x AAA 1.5V Battery (Not included)
Size: 77mm x 38mm x 17mm
8. Code 2: solder to the “H” side, like D4.
1) Press and hold button: The receiver vibrates.
2) Release the button: The receiver stops vibration.
How to pair the transmitter to the receiver:
1) Press the learning button of receiver for 1- 2 seconds; The LED on the receiver flashes one time. The receiver enters into status of LEARNING.
2) Press any one button on transmitter within 15 seconds. If the LED is on (or the receiver vibrates), it means learning is successful.
4) The receiver can learn several remote controls with different codes.
Delete all transmitters:
We have learned remote control to the receiver. If you don’t want the receiver to work with the remote control, you can delete all codes of remote controls, which are stored in the receiver.
Operation: Press and hold the learning button of receiver until signal LED from on to off (or the receiver from vibrate to stop vibration); release the learning button. That means all stored codes have been deleted successfully.