Direct power output; control Lights, Motors, Fans, electrically operated Doors/Locks/Windows/Blinds/Cars or Other Appliances.
You can turn on/off the receiver with transmitter (remote control) from any place within a reliable distance; the wireless RF signal can pass through walls, floors and doors.
With characteristics of reverse power protection and over current protection
Audible / visual indication
Use microcontroller model of EM78P156, an 8-bit microprocessor designed and developed with low-power and high-speed CMOS technology.
Reliable control: The transmitter (Encoding) and the receiver (Decoding) use an 8-bit code.
One/ several transmitters can control one/ several receivers simultaneously.
If you use two or more receivers in the same place, you can set them with different codes.
Transmitting Frequency: 315MHz / 433MHz
Model No.: S1PX-DC12 / S1PX-DC24
Channel: 1 CH
Control Mode: Toggle, Momentary, Latched
Coding Type: Fixed code / learning code
Coding Setting: By learning
Power Supply (Operating Voltage): DC12V±1V (S1PX-DC12), DC24V±1V (S1PX-DC24)
Output: DC12V (S1PX-DC12), DC24V (S1PX-DC24)
PCB Size: 74mm x 52mm x 24mm
Case Size: 79mm x 58mm x 35mm
Maximum Working Current: 30A
Maximum Power: 360W/12VDC or 720W/24VDC
Model No.: C-2
Channel: 2 CH
Remote Control Distance: 100m / 300ft (theoretically)
Encode: Fixed code by soldering
Unit Size: 58mm x 39mm x 16mm
Power Supply: 1 x 23A -12V battery (included, can be used for 12 months)
1) Setting control mode Toggle: Only connect Jumper-2. Press button 1: Turn on the relay, terminal OUT output DC power. Press button 1 again: Turn off the relay, terminal OUT no output.
2) Setting control mode Momentary: Only connect Jumper-1. Press and hold button 1: Turn on the relay, terminal OUT output DC power. Release button 1: Turn off the relay, terminal OUT no output.
3) Setting control mode Latched: Do not connect Jumper-1 and Jumper-2. Press button 1: Turn on the relay, terminal OUT output DC power. Press button 2: Turn off the relay, terminal OUT no output.
1 x Receiver: S1PX-DC12 / S1PX-DC24 (1 Channel / Three Control Modes)
2 x Transmitter: C-2
1 x User manual
The theoretical distance is 100m, which shall be operated in an open ground; no barriers and no any interference. But in actual operation, it is hindered by trees, walls or other obstacles, or interfered by other signals. Therefore, the actual distance can not reach 100m. If you need longer range, please choose other series of remote control, such as CB Serie (1000m/3000ft) - Click here; Or you can add the External Extend Antenna (model: 0020909) on the receiver for improve the range - Click here.