Direct power output; control Lights, Motors, Fans, electrically operated Doors/Locks/Windows/Blinds/Cars or Other Appliances with AC 100~240V.
Universal input: support voltage of AC110V (100V~120V), widely used in US, Canada... and voltage of AC220V (200V~240V), used in UK, France...
You can turn on/off the receiver with transmitter (remote control) from any place within a reliable distance; the wireless RF signal can pass through walls, floors and doors.
With characteristics of over current protection, short-circuit protection and temperature protection.
Audible / visual indication
Use microcontroller model of EM78P156, an 8-bit microprocessor designed and developed with low-power and high-speed CMOS technology.
Reliable control: The transmitter (Encoding) and the receiver (Decoding) use an 8-bit code.
One/ several transmitters can control one/ several receivers simultaneously.
If you use two or more receivers in the same place, you can set them with different codes.
Transmitting Frequency: 315MHz / 433MHz
Working distance of transmitter and receiver with external extend antenna: 2000M / 6000ft (theoretically)
Model No.: S1PX-AC220-ANT2
Channel: 1 CH
Control Mode: Toggle, Momentary, Latched
Coding Type: Fixed code / learning code
Coding Setting: By learning
Power Supply (Operating Voltage): AC100~240V
PCB Size: 74mm x 52mm x 24mm
Case Size: 79mm x 58mm x 35mm
Maximum Working Current: 30A
Maximum Power: 6600W/220VAC or 3300W/110VAC
External Extend Antenna:
Frequency Range: 300~450MHz
Antenna Length: 15cm
Cable Length: 150cm
Anti-interference, waterproof, shielded wire set inside
Magnetic stand design for easy to install
Model No.: CB-2
Channel: 2 CH
Remote Control Distance: 1000m / 3000ft (theoretically)
Encode: Fixed code by soldering
Unit size: 135mm x 42mm x 25mm
Power Supply: 1 x 6F22-9V battery (included, can be used for 12 months)
1) Setting control mode Toggle: Only connect Jumper-2. Press big button: Turn on the relay, terminal OUT outputs AC power. Press big button again: Turn off the relay, terminal OUT no output.
2) Setting control mode Momentary: Only connect Jumper-1. Press and hold big button: Turn on the relay, terminal OUT outputs AC power. Release big button: Turn off the relay, terminal OUT no output.
3) Setting control mode Latched: Do not connect Jumper-1 and Jumper-2. Press big button: Turn on the relay, terminal OUT outputs AC power. Press small button: Turn off the relay, terminal OUT no output.
1 x Receiver: S1PX-AC220-ANT2 (1 Channel / Three Control Modes)
1 x Transmitter: CB-2
1 x User manual
The distance of 2000m is a theoretical data, it shall be operated in an open ground, no barriers, no any interference. But in the practice, it may be hindered by trees, walls or other constructions, and may be exposed to some interference by other signals. Therefore, the actual distance can not reach 2000m. It depends on the actual working environment.