This 110V 220V 4 x 1 channel radio remote controller has the special ability to learn remote codes, allowing it to be used in one-transmitter-to-many-receivers system. Easy to operate by toggle mode. Just press slightly the button on the remote, you can control universal electrical devices. It is applied for remote controlling light, motor, gate, garage door, etc.
Control Lights, Motors, Fans, electrically operated Doors/ Locks/ Windows/ Blinds/ Cars or Other Appliances.
You can turn on/off the receiver with transmitter (remote control) from any place within a reliable distance; the wireless signal can pass through walls, floors and doors.
Reliable control: The transmitter (Encoding) and the receiver (Decoding) use an 8-bit code.
One/several transmitters can control one/several receivers simultaneously.
If you use two or more receivers in the same place, you can set them with different codes.
Transmitting Frequency: 315MHz / 433MHz
Model No.: S1T-AC110 / S1T-AC220
Channel: 1 CH
Control Mode: Toggle (Press -> On; Press again -> Off)
Coding Type: Fixed code
Coding Setting: By learning
Power Supply (Operating Voltage): AC100~120V (S1T-AC110), AC200~240V (S1T-AC220)
PCB size: 80mm x 35mm x 14mm
Case size: 100mm x 40mm x 24mm
Maximum Working Current: 3A
Model No.: CV-4
Channel: 4 CH
Remote Control Distance: 500m / 1500ft (theoretically)
Encode: Fixed code by soldering
Unit size: 110mm x 50mm x 18mm
Power Supply: 1 x 23A -12V battery (included, can be used for 12 months)
Connect the neutral wire to the terminal “1”, and the live wire to the terminal “2”. Connect the lamp to the terminal “5” and the neutral wire. 1) Press button 1, turn on the lamp of receiver 1. Press button 1 again, turn off the lamp of receiver 1. 2) Press button 2, turn on the lamp of receiver 2. Press button 2 again, turn off the lamp of receiver 2. 3) Press button 3, turn on the lamp of receiver 3. Press button 3 again, turn off the lamp of receiver 3. 4) Press button 4, turn on the lamp of receiver 4. Press button 4 again, turn off the lamp of receiver 4.
We have learned remote control to the receiver. If you don’t want the receiver to work with the remote control, you can delete all codes of remote controls, which are stored in the receiver.
Operation: Press and hold the button of receiver about 4 seconds until signal LED turns off; then release the button, at this time all stored codes have been deleted successfully.
Learning the button of remote control: 1) Press and hold the button of receiver about 2 seconds until signal LED flashes; then release the button, at this time the receiver enters into status of LEARNING. 2) Press any one button on remote control. If signal LED immediately turns off, it means learning is successful. 3) The receiver can learn several remote controls with different codes.
4 x Receiver: S1T-AC110 / S1T-AC220 (1 Channel / Toggle Control Mode)
1 x Transmitter: CV-4
1 x User manual
The theoretical distance is 500m, which shall be operated in an open ground; no barriers and no any interference. But in actual operation, it is hindered by trees, walls or other obstacles, or interfered by other signals. Therefore, the actual distance can not reach 500m. If you need longer range, please choose other series of remote control, such as CB Serie (1000m/3000ft) - Click here; Or you can add the External Extend Antenna (model: 0020909) on the receiver to extend the range - Click here.